Davedstone
Member
I had cause to remove air the intake valance in order to remove the wiper motor assembly to access the cable which goes through the bulkhead. Now I have come back to refitting this and I am struggling trying to get this to line up on the side where the small screws either side which screws to the base unit.
I have attached pictures and if anyone has had cause to remove this and refit. What am I not doing in order to get this to line up without force.
Many thanks in anticipation.
I have attached pictures and if anyone has had cause to remove this and refit. What am I not doing in order to get this to line up without force.
Many thanks in anticipation.