jp928's latest activity
-
jp928 replied to the thread Seeking Outdoor P6 Car Cover Recommendation.I have used a cover outdoors once, but it ended badly due to extensive mould occurring inside the car. Things to watch for - best fitted... -
jp928 replied to the thread Cam type and timing question.Check out this list...note layout due to printing from XL. The notes at the end are sometimes very relevant.
-
jp928 replied to the thread 3500S badge (3x) + Police spec spoilers.I suspect 3d scanning and printing would be cheapest way to recreate these. Friend who is very good with copying FG items reckoned it...
-
jp928 replied to the thread Electrical issues.Unlikely the cap , as usually some of the contacts would work. Rotor shorting to ground maybe. Check for wiring inside dizzy is...
-
jp928 replied to the thread Kühlwassertemperatur wird nicht mehr angezeigt.Looking in at the engine, on your right side, below the cover that has the hose to the top of radiator is the sensor - points to the...
-
jp928 replied to the thread Rover P6 renewing project after 42 years barn live..Doing a lot of work there, well done. Rubber seal under the heater is 369294, also used in Range Rover- available here - Foam Gasket -...
-
jp928 replied to the thread Kühlwassertemperatur wird nicht mehr angezeigt.You are very welcome - this is what we are here for, to help people keep these on the road, and what comes around, goes around.
-
jp928 replied to the thread Servo valve spring?.Ron, I was confused initially, but finding that spring in another booster of the period reassured me. I never found one in a diagram of...
-
jp928 replied to the thread 3500S badge (3x) + Police spec spoilers.Dont recall now - it was 30+ years ago now. Must have been something about it crabbing. A group of used to travel in convoy when we went...
-
jp928 replied to the thread 3500S badge (3x) + Police spec spoilers.You mean 'yet to find a car ISN'T' ? Had S2 Disco once, where the fit of the wheels in the arches looked fine (ie symmetrical), but the...
-
jp928 replied to the thread Servo valve spring?.Good to know, thanks.
-
jp928 replied to the thread P6B S Project Car.A bit of luck lately. Looked for ages for a windage tray, finally found one used on WINS! Then I found an SD1 oil pickup locally...
-
jp928 replied to the thread Kühlwassertemperatur wird nicht mehr angezeigt.Locate the sensor on the engine. pull the wire and ground it to engine - gauge should now go full scale. If yes lead and gauge are good...
-
jp928 replied to the thread rover V8 hydraulic lifters.Note that the oiling system is not symmetrical. The RHS oil gallery down the block supplies the RHS lifters and main bearings and rods...
-
jp928 replied to the thread Brake Servo- Booster air valve spring.Wish I had found this thread before I posted my query on the larger dia spring! At this age the booster has almost certainly been...